Inline RCDs: Non-Latching Protection for Power Tools

An inline RCD is fitted into a suitable cable lead to provide additional protection against certain electrical faults. Before buying one, check the device rating, cable compatibility and whether you need non-latching operation. It is different from a plug-in RCD adaptor.

Fixings Direct supplies the Masterplug ILRCDNG 13A non-latching inline RCD. This guide explains its main buying points; fitting and testing must follow the manufacturer’s instructions.

Masterplug inline RCD with orange reset and red test buttons
Existing photograph of the Masterplug inline unit. Cable, plug and connected equipment are not shown.

What does an inline RCD do?

An RCD detects some electrical faults involving current leakage and disconnects the supply. It can reduce the risk of injury, but it does not make damaged equipment safe or protect against every type of electric shock.

For outdoor power tools or garden equipment, consider the complete supply arrangement: the tool, cable, connections and existing protection. Check the equipment manufacturer’s requirements and ask a competent electrician if you are unsure which device is suitable.

What does non-latching mean?

With this Masterplug model, interruption of power to the RCD causes it to trip. When the supply returns, it needs a manual reset before power reaches the connected equipment. This includes a power cut or switching off the mains supply to the unit.

That behaviour matters when comparing latching and non-latching RCDs. Choose according to the application and equipment requirements, rather than treating the reset as an inconvenience to bypass.

13A and 30mA describe different ratings

Specification Masterplug ILRCDNG
Maximum current 13A
Maximum load 3,120W at 240V AC
Rated trip current 30mA
Typical trip time 40 milliseconds
Operation Non-latching; double-pole disconnection
Casing rating IP65, subject to correct fitting and assembly requirements

The 13A value describes the maximum current rating. The 30mA value is the rated residual trip current, not a time measurement. Do not read “30mA” as “30 milliseconds”, or assume that a higher current rating makes an RCD the better choice for your equipment.

Inline RCD or plug-in adaptor?

An inline unit becomes part of a suitable flexible cable lead. A plug-in RCD adaptor fits at a socket without the same cable installation work. They are different formats, so check which arrangement the application requires before ordering.

The ILRCDNG is a rewireable device. Its instructions specify the permitted cable type and size. Have it fitted by a competent person, with the supply isolated, and follow the exact instructions rather than relying on a general wiring diagram.

Is an IP65 inline RCD waterproof?

IP65 describes the casing protection under the specified conditions. It does not make a whole extension lead waterproof or suitable for immersion. Masterplug requires plugs, sockets and connectors of an equivalent rating to maintain the assembly’s IP65 protection.

Keep equipment within its intended operating conditions and inspect the cable and connections before use. An outdoor application still needs a suitable complete assembly and safe positioning.

Testing and repeated tripping

Test the unit before each use using the manufacturer’s procedure. If it fails the test, the case is damaged or it repeatedly trips, stop using it and seek expert advice. Do not bypass it or keep resetting it to continue using equipment with a suspected fault.

HSE guidance on electrically powered equipment explains why RCDs provide additional protection alongside normal electrical precautions.

Which inline RCD should I buy?

Match the voltage and current rating, cable requirements, operating type and environment to the equipment and supply arrangement. The Masterplug ILRCDNG product page has the exact specification and Download datasheet button, including the manufacturer’s fitting and test instructions.

Browse our Masterplug range for other power accessories. Select each accessory for its own application; an RCD is one part of the electrical safety arrangement.