SikaBond 5500S Parquet Adhesive: How Much Do I Need?

SikaBond 5500S is a ready-to-use, solvent-based adhesive that forms a rigid bond. Sika specifies it for full-surface bonding of suitable wood block parquet and engineered boards onto prepared porous subfloors. Check your flooring manufacturer’s instructions first, especially if they specify a different kind of adhesive.

SikaBond 5500S wood flooring adhesive 16kg pail

How much does one 16kg pail cover?

Sika lists consumption of 0.95–1.25kg/m², depending on the notched trowel and the subfloor profile. Dividing 16kg by that range gives approximately 12.8–16.8m² per pail before waste. For example, a 15m² room could use about 14.3–18.8kg before allowances. That makes the trowel and surface important when deciding if one pail is enough.

Can it go over old parquet adhesive?

Sika identifies wood-block refurbishment involving bitumen adhesive residues as a use for 5500S. Check the condition and identity of the existing layers and follow Sika’s preparation instructions before ordering or disturbing old material. The flooring needs full contact with the adhesive, so check the subfloor is sound, dry and suitably prepared.

What if the room has underfloor heating?

Sika allows use over suitable underfloor heating installations within its commissioning, moisture and temperature limits. Check the flooring manufacturer’s requirements as well. Read the technical sheet before setting the heating schedule for installation and curing.

When can I walk on or sand the floor?

Sika gives about 48–72 hours before walking, sanding or finishing, depending on the site conditions, subfloor absorbency and adhesive thickness. Plan the work in sections within the stated laying time. Read the product and safety sheets before use, including the ventilation and ignition precautions for this solvent-based adhesive.

See SikaBond 5500S 16kg or browse Wood Adhesives. Sika product data sheet