Type 4 Cavity Wall Ties: 225mm, 250mm or 275mm?
If the masonry design calls for Type 4 housing ties, check the actual cavity width before choosing the length. Fixings Direct VE4 Type 4 cavity wall ties connect the two masonry leaves in suitable light-duty housing applications. They’re made from grade 304 stainless steel and come in packs of 50 or 250.

Which wall tie length fits my cavity?
| Cavity width | Tie length | Drip arrangement |
|---|---|---|
| 76–100mm | 225mm | Central multi-drip |
| 101–125mm | 250mm | Central multi-drip |
| 126–150mm | 275mm | Two offset double-drips |
The table is specific to the Fixings Direct VE4 range. For example, the 275mm measurement is the full tie length. The supplier’s cavity range for that tie is 126–150mm, leaving length for the tie to sit in the mortar joints on both sides.
Is Type 4 right for my wall?
Confirm the tie type with the wall design first. VE4 is a light-duty tie for specified domestic masonry cavity walls. The October 2026 datasheet gives limits for building height, site wind and altitude. Follow the project design for embedment, spacing and extra ties around openings. Where insulation needs retaining clips, check compatibility and order these separately.
Should I buy 50 or 250 wall ties?
Use the project’s tie layout to count the total needed, including any positions at openings and edges. If different sections have different cavity widths, count each length separately. Then compare 50 and 250 packs on the product page.
Choose your length of Fixings Direct Type 4 stainless steel wall ties and use the datasheet on the product page to check the application limits. Browse Cramps & Ties for related hardware.