Heat Resistant Grout for Fireplace Tiles: Coverage and Finish
Once the tiles are fixed around a fireplace or behind a wood burner, use a grout suited to the temperature and the width of the joints. VITCAS HRG grey heat resistant tile grout comes as a 2.5kg powder to mix with clean water. VITCAS rates it up to 1000°C when used as specified. Check that the tiles, adhesive and substrate suit the intended exposure too.

How much heat resistant grout do I need?
VITCAS gives an approximate coverage of 2m² with 200 × 200mm tiles and 3mm joints. Measure the tiled area and check the joint width and depth. Smaller tiles typically put more joint length into the same area, so check your layout before using the example to order. This grout is intended for thin tile joints up to 3mm.
What will the grey grout look like?
A reviewer on VITCAS’s site found the grout easy to work with behind a wood burner. Another highlighted how much colour choice matters on a finished job. Our 2.5kg listing is grey. VITCAS notes that the shade can vary with batch, mixing and drying, so let a small sample dry before judging it against your tile. If you need several tubs for one visible area, check the batch labels before starting.
When can I grout after fixing the tiles?
Wait for the adhesive to set fully. When using VITCAS HRTA, the manufacturer gives approximately 72 hours at 20°C, with cooler or damper conditions potentially taking longer. Mix the grout to a workable consistency, fill the joints with a grout float and follow VITCAS’s guidance on wiping away excess. Let it dry before heating the installation.
Which product goes where?
Adhesive bonds the tiles to the surface. Grout fills the joints between the tiles once the adhesive has set. For help choosing the earlier layers, see our fireplace tile adhesive guide.
Shop VITCAS heat resistant grey grout and browse the VITCAS collection for related tiling materials.